Ron,

There is just enough room to fit the boards in fairly easily. The coprocessor board basically sits on top of the 3x SPDIF output board and there is a space in the XA2 where that fits in.

I just put a few pictures of the install in Vince's XA2 online here:

http://switch-box.com/S_PDIF_installation/Entries/2008/2/11_Toshiba_hd-Xa2.html

As far as performing the mod itself it is pretty similar to installing an SDI output if you have ever done that. You would need very fine wire and a fine tipped soldering iron for the mod, I use 30 gauge kynar insulated wire wrapping wire and a Metcal MX-500.

Thanks,

Shawn

Last edited by sfogg; 2008-02-12 05:18.
.