I'm running a 568 with 6000's front left and right and 5000's center and rear. The 5000c is set to master.

When adjusting the volume the 568 adjusts faster that the speakers. The speakers, while out of agreement with the 568, are in sync with one another. This become a problem because I'm running an analog sub so sometimes the sub volume is much higher than the speakers (since the sub is controlled by the 568).

I can re-sync everything by restarting the 568 and the 5000c; however, as soon as I start to adjust the volume everything goes out of wack, again.

I should note that the speakers do adjust to volume changes - just not as fast as the 568.

Any ideas???

Thanks!!!