Hi Steve
The speaker I looked at yesterday was set to t0.0 /b0.0 so going to 2.0 or 2.5 on the treble isn’t going to far?
Would you expect this to have any long term negative effects like reducing the life of the tweeters?
Also just looked at the other speaker and that one is set to -0.5 on both the bass and treble.
My speakers started life as d6000s but after I had the panels repaired a few times i gave up on them and I bought a full set of 18bt electronics of eBay that just happened to come up at the right time.
If you recall I sent them to you for a full recap then back to you for a 24bt upgrade.
The reason for the quick history lesson was to ask if you know, would the -0.5 setting be to calibrate for differences in drivers or panel electronics?
If it’s the electronics then I should keep the difference between them, if it’s the drivers then I will make them both the same, would you agree?
Graham

G61r, HD621, DSP6000, DSP5500.2HC, M2500 sub, DSP5000.2 rears, DSP5000 sides,
G98DH, 504, MC200, Control:15, Roon