Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Restaurant at the End of Universe Hitchhikers - Service, Repair, Custom Leads & Interfaces DSP5200 non-SL recap

Well played around Alot with mounting locations and cooling. Used some standoff's to mount the resistor bank off the board; looked great but 150f was dumping right on the caps. ordered some 10w chassis mount, remote mounted them to the chassis ~ heat is very under control. The regulators were... well a lot of fun, unfortunately the thermal pads i used were slightly conductive... prompting several re-mounts, leading to the not nice looking long leads. new pads fixed the short. have some clean up with the bolts for the regulators. Pending longer testing, heat sinks can be added by easily (if required).
Final regulator mounting, and remote resistor leads

Remote mounted Resistors right to chassis above DSP shield

Clean vertical mounted regulators and Resistors on standoffs