Hi, Carl.

I am reading this post and trying to implement the RS232 cable to RJ45, but until now, no success!

I am using the USB to RS232 that in the past I used to update the G68/DSP7k/DSP5kC and connecting the TX and RX wire of the to a cut into ethernet cable, I flipped both to see if it changes something, but no success.

The RS232 commands that I following are the ones I found and the paper for a DSP420 speaker, SB for stand-by and also some other codes like EAON (Enhanced bass on) and some others, but the speaker didn't change its status and I never receive a feedback message from the M6. Is there a specific RS232 codes special to the M6?

Thanks for the help.

Regards,
Jorge