Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems G68 Room correction filters

Hi all,

Have tried to research this here can not find specific info.

I have run room correction all went well but after storing, even though the unit said correction was successful there were no filters applied/saved.

Am I missing something, shouldn't there be some filters?

Maybe I’m doing something wrong or am I just misunderstanding how this works.

Any help would be greatly appreciated. Thank you.

Did you find WiKi - Meridian Room Correction Tips and Tricks?

Thank you for the link.

Hi!

Where did you find the software to perform the Room Correction?

I am looking for it, as well as the latest firmware to update de G68, the DSP7000 and the DSP5000C.

If you could point me to somewhere I can download it, I will really appreciate the help.

Thank you!

The room correction software came with my G68 . I believe they all did. It can be accessed from the Meridian config program. The config software is on meridians website (or used to be) download that and then connect the g68 to a computer and follow the directions.
Hope that helps

Thanks for the reply.

I was unable to locate the software in the Meridian’s website.

I was logged in, but the site seems to do not have legacy software or even information about legacy products like the DSP7000.

I probably will need another root to download it.

Thanks again.

Thank you very much for the link.

I will download it and try to install tonight.

Thanks again.