Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems G68 subwoofer connection and setup

I'm new to subwoofer setup and have a few ?'s:

- I have the G68AXV, and my sub has single-ended inputs only, one for LFE, and a L/R set; what's my best bet here? Should I get a cable that has XLR on one end and RCA on the other and use the balanced sub out on the G, or is there a way to configure some of the additional single-ended outs for the sub? Not clear from the manual to me.

- Any advice on using the sub/sine/sens routine?

- Any other advice?

Thanks all.

I had the same problem. M advised me to obtain an XLR to phono adapter from Maplins. Worked perfectly for me. The adapter was inexpensive (I did get it from Maplins if I remember correctly) and you can then run a standard screened phono cable to your sub (usually you only need one - either left or right or the LFE depending on your preference). (Much less expensive than a long XLR cable).

Use your ears rather than your meter to set the sub level would be my only other advice.

Cliff