Hello everyone,
I'm in need of a little help.
I recently purchased a MS200 off eBay. The seller assures me it is 100% functional.
My MC200 however cannot see it (yes it is plugged into the same network. Moreover I simply unplugged an existing MS200, putting the new one in its place.)
When I perform an network scan, is is not visible either.
I've asked the seller this question: Was the MS200 IP address defined, and if so what subnet. This being the case, DHCP would have been deselected.
So my question to you all is: Can the MS200 be reset to factory condition, where one assumes DHCP is active by default?
Thanks for any help that any of you can furnish.
Trevor

#1: 861v8, UHD722, 808v3, 2xDSP8000.2, DSP7200.2, G68, G98, 2x5000C, 2x5000.2, 5200C, 6x5200, 601, 602, 604, D600x4, 200, 203, 562v3, Explorer, Opp0203, TD20aSE, RX505, JA555, CNX, 3xAC200, 6x3200