Hi

I recently purchased a pair of Mark III DSP6000's which were seriously damaged in transit. Smashed glass, dinged corners and serious damage to the head units which probably puts them beyond economic repair.

I was wondering if I could use the boards to upgrade another pair of Mark 1 speakers that I have to 24/96. The concern that I have is the change of display and I was wondering if it's possible to use the Mark 3 boards with the Mark 1 LCD segment display otherwise I would either need to purchase new glass or mangle the Mark 1 glass to allow the Mark 3 matrix display to be visible.

There are 3 jumpers on the board (think 6Kc14.pcb?) and I was wondering if any of them would allow me to select the older display type?

Any help appreciated:

1) Any way I can configure the Mark 3 board for use with Mark 1 displays?
2) Is there any different firmware that would solve the problem? If so is it upgradable easily or would I need to remove the EPROM?
3) Any idea of cost to source replacement glass.
4) Any idea of cost to repair / replace the head units?

Thanks in advance.

Steve