Hi Richard,

The Control:15 is fairly easy to disassemble... Need to take a few screws out to get the top and bottom screen covers off, be careful of the short wire to the on/off switch.

Next, there are six screws that attach the front metalwork that holds the screen and motherboard.

Be VERY careful when you finally extract the screen/motherboard unit - the wires are short and there are a lot of them... Take plenty of pictures and disconnect everything very carefully as connectors can easily break.

There are also some heatsink pads - make sure you don't damage them. The touch-screen is five-wire (not RS232 or USB) and the screen is a special connector, so using a different motherboard is a bit difficult.

Other fellow HH'rs have managed to get the motherboard to run Windows 10 but there are driver issues. If you search the forum, you should find some information.

Good luck with your endeavours.

Cheers,
Steve

Main: 861v6 (LPS), 808v6, UHD722, DSP8000SE Anniversaries, DSP5200.2HC, DSP7200.2, SW1600, Sky Q, Cambridge Audio BD, Roon, M80
Office: 861v4 (LPS), 818v3, 800v4, HD621, M&K S150P, DSP5500HC, M&K MPS2810 sub x2
Son's system: 861v4, HD621, DSP6000.2, DSP5200HC, DSP33
Spare: MCD, 100 Series, 200 Series, 500 Series, F80s, C15s.