Hi all,

In my cinema room I am running G68 controller with full legacy speakers and MC200. For comms I have SpeakerLink from MC200 to G68 and audio I use digital SPDIF into G68.

All speakers are type 6 set up.

Other sources I have is Sky Q and my PC which has high end SPDIF sound card output. I want to keep these in full cinema surround.

The G68 is set as controller. Centre is master all others slaves via 511 patch.

With the 818v3 I want to go direct to the speakers for the best sound quality. With this I will use 818v3 for streaming Tidal etc. and my MC200 moves to another room. I only listen to stereo for music as for me it's the best sound quality.

How can I get D2 on my left front speaker to take input from 818v3 as a source with a set key on the MSR+ / Tidal app or without gong 818v3 into G68 how should I wire the entire set up?

I am aware I could go G68 into 818v3 and 818v3 to speakers. But again how do I set this up?
I would prefer just to keep them separate so 818v3 just goes into D2 and I have control comms between 818 and G68.

I checked on the Meridian setup software and could not do this config at all. As G68 can't be set as a source to 818v3 only other way around.

Please help with this as I sure this is the best place to ask.

www.8Pack.co.uk