Just trying out my 7200.2's as a stereo pair in a different room instead of my movie based system, they are being fed via a MC200.

I have set them up as type 1 and they work fine but when I go into setup and change them to corner and adjust the balance to deal with my dodgy hearing, the settings don't appear to save, according to the manual you just power on and off. When I go into normal operation the balance is back to neutral so assume I have also lost the corner setting as well.

Is there a way to check the firmware version I have, hasn't been updated for a few years but not aware of any recent changes. I recall that to do the last firmware upgrade I had to borrow a special cable from the dealers as the 7200's don't have a RS232 port.

I have set the EBA setting to 'Y' is this correct for this setup.

On the subject of EBA, was a firmware patch ever released for the 5500's.

Thanks,
David

861v6 ID41, HD621, G98, MC200, DSP7200, DSP7200HC, DSP5500 (rears), D2500; Oppo BDP83, PS3,
- Other rooms 3100, F80