Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Streaming Hardware with Roon Application Comms Wiring - MS200 via Reviver into DSP3100s

Related to my post in the Systems forum.

I am moving my MS200 from G68 connect to direct connect to the DSP3100s.

I have a Reviver with DIN comms and a DIN to BNC adapter purchased from @Mi'. DIN comms come from the G68 and therefore I have used the BNC comms input for the Reviver.

As I cannot use the system in quite the way I intended atm - G68 to D1 and MS200 to D2, I have experimented with just the MS200 connected to D1 via the Reviver.

Good news I get music from Roon, bad news is I get no comms function - Roon does not 'wake' the speaker up nor does the Roon volume slider affect the speaker volume.

I unplugged the DIN comms input from the G68 and used that directly with the Reviver and it exhibited the same behaviour - so that discounts a faulty adapter or BNC comms connection.

The DSP3100 that I am connecting to is Master and Controller. I have enabled SpeakerLink on the MS200 config page - although music happened without this enabled.

So I don't know if I have wired this incorrectly, not specified something in the MS200 config or the reviver is not performing as I would expect.

Many thanks for any suggestions