Yes, I have in the past used the wizard to configure the sources and the various speaker distances, presets and lip-sync. As I haven’t managed to get any sound since the repair, these settings are not very relevant yet. I have used the wizard to check that aux is still set up for SLS to connect the MS200. I have also tried an analog source to connect to Tape (which I saw was on A4). All to no avail.

I have also in the past used the Configuration Program, but I find this very hard to operate reliably, so have given up on it. I have a saved working setup somewhere, but haven’t tried to connect to the G65 yet.

What I’m trying to explain is that I understand and have used some of the tools available (apart from typing). Over the last few days I have tried a lot, but am now getting very frustrated.

MS200, G65, 2xDSP5200SE, DSP5200SEHC, HD621, Oppo BDP103,
MD600, MS600, Accuphase 203, 2xTotem Mite
various Sonos units (MC200 in storage)