Hi all,

I’ve just received my G65 back from the dealer. Power supply was replaced and it is indeed switching on again, however, I can’t get the system to play again. Is there a step by step guide for setting up the system; I’ve worked through the manuals of the DSP and the G65, but can’t get a squeak of sound out of the speakers.

I did reconfigure the DSPs so I could listen through the MS200 while the G65 was being repaired and this worked fine. (Means the speakers are still OK) I’m now trying to retrace my steps and have changed the DSPs to Type 6 which I believe was the original setting. I have even reset the G65 to Type 5 and configure the speakers for just two large SpeakerLink speakers.

The L is the master, R is slave. The G65 is the Controller, L shows "No contr", R doesn’t show either. The weird thing is that the source selection is visible in the speaker displays and so is the volume. Just no sound...

I’m sure it is something simple, but I can’t work out what it is. hence the guide for dummies.

Any suggestions?

MS200, G65, 2xDSP5200SE, DSP5200SEHC, HD621, Oppo BDP103,
MD600, MS600, Accuphase 203, 2xTotem Mite
various Sonos units (MC200 in storage)