Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems No noise during Room Correction

Sorry to hear that.

Sorry to ask that again, does have the left front DSP a red light in the display?
That is important as the red dot have to be in the Mconfig-file (what is it) and at the same physical DSP.

I checked now with my v6 and legacy DSP the whole sequence for you.
At which number the dialog stops and does your DSP display(not the processor display) show that ?

Hit Start on the Menu "Room correction"

A popup window appear "beginn(counts)" and "cancel"
and disappeared after the countdown finished.

1) "the product connected to comx is a Meridian ..."
2) "Storing..."
3) "Writing settings..."
4) "Reading documents.."
5) "Earising memory.."
6) "Storing documents.."
7) "Storing profiles..."
8) "Storing room corretion data.."
9) "Resetting product..."
10) "Waiting for product to reset.."
11) "Initializing product.."
12)"Selecting source...">> the DSP display show "CD 47"*
13)"Starting measurement of Front left(Music....)
14)"Setting volume to 87..">> the DSP display show 87 and the noise appear
15)"MLS measurent.."
16)"Calculating impulse response..."
17)"Calculation complete;power=-48dB, SNR=0dB."
18)"Set volume to 50.."
Power is too low....that is the typical error message when the processor get no or a to weak signal

** The number beside the source is the "power up volume" what you have choosen in the MC-file.Maybe you edit that from "last valid" to a certain number.
You will find that on the 861v4 when you make a right click with your mouse under "Properties" and then under "setup".
Its also a good thing always to change that volume number as then its easy to see that the processor have go the mc-file correct.

What is on the display on your v4 shows during that procedure?

You got also a PM here.