Are the Speakers Displaying 87 Volume when it goes to calibrate?

Who is the Master?

How are COMMs setup?

Sounds like a COMMs configuration issue to me.

Nothing to do with MIC (Yet), since you are not getting any sound out.

Without using the IR Remote Control, Starting with EVERYTHING in stand by (861 and Speakers) can you Select a Source from 861 and play music?

If you have for example two Masters (861 and one Speaker) you might be sending IR commands to both and have it "working" (with improperly setup COMMs).

But when the 861 is under control there are no simultaneous IR commands going to the speakers to make it "work" under MRC.

You did say Speaker Calibration is working, which uses the same means of controlling the speakers. So it's a bit odd that MRC does not work but Speaker Calibration does.

As a work around have the system playing music. STOP the Music and set speakers to 87 (DON't HIT PLAY). Don't shut the system off with the remote. Shut it off from the 861 and then try MRC. This would leave your speakers in the correct state for MRC even if the 861 is not controlling them.




Last edited by Fiddler; 2016-12-27 20:52.
- Fiddler (IMHO)

If you think listening to music is fun, try learning an instrument.
HT: G61RSL, 4x5K, 5.5KHC, 2xSC6000, Transporter, HD621, Philips BDP7501 4K, Tivo, 65" LG OLED 4K C6
Computer: Foobar2000, 5K, Mojo, HiFiMan HE1000 V2