Hi Matt,
To answer your questions:
Originally Posted by MattF
I'm not bothered about comms routing, I'd like to know whether the distributor can be configured to deal with the input selection per source (however it gets selected)
Yes it can. This is done using the Meridian Program "Control Window" which is part of the Common Installer pack. This is the USB configuration that you mentioned.

Originally Posted by MattF
Is there any chance Meridian will start releasing information like they used to instead of pamphlets with comments like 'See the RS232 documentation for the connected DSP' and not linking to the document from anywhere (other than mentioning they were updated in the last firmware release for M6)?

I have to admit, the 'User Guide' for the Distributor 1 fell below my already very low expectations - has even less information than the Distributor 3 (what does 'USB configuration mean - and how)
There is a detailed Technical Note on how to configure the Distributors 1 & 3. This along with the RS232 documentation is only available from Meridian with a Partner login. However, I'm sure that your local dealer would be able to help you with this. If they can't, then just let me know and I'll try and help you further.

Separately, I think that due to the interest in this product I will get one in for demo purposes.
Thank,
Peter



Clever & Simple
Meridian Dealer In South West London
for my personal account please see PeterRW