I'm not bothered about comms routing, I'd like to know whether the distributor can be configured to deal with the input selection per source (however it gets selected)

Distributor 3 manual implies that source configuration is hard-coded - i.e. CD=digital, Radio=Analogue, Aux=SpeakerLink.

To try and clarify - for each of the 12 posibilities of Meridian System wide 'current source' synched via comms, can the selection of each input on the distributor be configured:

1 Digital
2 Digital
3 SLink (3/4 might be swapped - can't remember offhand)
4 Digital
5 Digital
6 Digital
7 Digital
8 Digital
9 Digital
10 Digital
11 Digital
12 Digital

(Analogue not used)

Is there any chance Meridian will start releasing information like they used to instead of pamphlets with comments like 'See the RS232 documentation for the connected DSP' and not linking to the document from anywhere (other than mentioning they were updated in the last firmware release for M6)?

I have to admit, the 'User Guide' for the Distributor 1 fell below my already very low expectations - has even less information than the Distributor 3 (what does 'USB configuration mean - and how)

Matt