OK...I THOUGHT I was finished asking questions.

I found my USB>Serial cable and figured I should go ahead and update all the firmware on the system. The G68 was done a few days ago, so I hooked up the DSP7000's and once I had the files in the Flash Uploader and started it, it asked for a manual reset (Power off/On) and everything went flawlessly. Got the mains done and moved to the DSP5000C...it asks me to do the same thing but when I do it never sees the speaker and starts the update.

Do the 18-bit systems need a different COMM config? I'm set at the default: 9600, 8 bits, none (parity), and 1 stop bit with no flow control.

I know the cable works...it did the first 2 without a hitch.

Any ideas?


G68D, DSP7000's, DSP5000C (18 bit), DSP420's, MF-1 Projector, Sony XBR-65 4K