Originally Posted by Carl
T2 = Selected source, in this case Tape 2.
63 = Volume level.

Though T2, is a 500 service source not a G series one, which suggests that the 5000 is configured for 500 and G comms.

I recommend you download both the DSP and G68D user guides from Duncan's Meridian site. Be prepared to read them many times ... we've all done so.

Regards,
Carl

PS Do you know if the DSP5000HC is 18bit bit or 24 bit version.
Carl,
Specifications say it is 18-bit Delta-Sigma converter running with 64x over sampling.

I have ALL the hard copy manuals for everything...just when I think I've got it figured out I get hit with another gotcha.

I selected type 6 (500 Mode, Merdian Digital Theater) when I set it up, but I have basically 3 choices for mode from the 8 "Type" factory pre-sets:

500 Mode
208 Mode
201/601 Mode

Does this mean I can't use this DSP5000C with my G68D? I've looked through the G68D manuals for speaker configuration types and it has nothing in it on them. The configuration is basically analog or digital, DSP large or small and that's pretty much it.

I've put it back out of the way for now...I'm going to wait until later this week when SHE goes on a business trip to sit down and look into it further. I was just wanting to see if I could get it up & running quickly to make sure everything was fine. I've got painting and trim work to do in this room to replace damaged stuff from the water...and so I don't want it to get damaged from not paying attention.

Last edited by JRaymond; 2015-06-14 20:05.
G68D, DSP7000's, DSP5000C (18 bit), DSP420's, MF-1 Projector, Sony XBR-65 4K