Hi John,

Firstly you'll need a way of connecting to the RS232 part of the DSP3200 SpeakerLink input connector, as they don't have a 9 pin RS232 port. The AC11 should provide this connection, using the master SpeakerLink port.

Then start up Meridian Configuration program.
Go to the Control Window
Command Tab

Firstly use the default command of ID to check the firmware of the DSP3200, and confirm you have connection.
You'll need to be on firmware 1.2.0

Then type EAON in the command line (where ID was) and press Send

The DSP3200 should report back that E(B)A has been turned on.
This is a non-volatile command, so will remain even if the power is removed.

You need to set EBA On in each speaker individually, that's very important! The command is not passed from one to the other.

Rick

Audio Images, 284 Glossop Road, Sheffield, England. Tel: 0114 273 7893
Website: www.audio-images.co.uk Email: Click here to email Rick