Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems MSR+

I got this from the manual on Duncs site:

The DVD player provides three standard settings, called Types, which configure the 596 into the most commonly needed configurations.

Choosing one of the three Types overrides any other configuration you may have performed, and so can be used to reset the configuration of the unit.

The types are summarised in the following table:

To restore the standard settings; Switch the 596 to standby.
Hold down Off (front panel). After a short delay the display will show:
Press left or right on the front panel to change the Type number.
For example, if you select Type 1 the display shows:
Wait until the display shows:
The display then shows:
Press Off to switch back to standby.
Switch on again to use the 596 with the standard setting you have selected.

596 manual try page 52.

Chris