3. The DSPs are connected in home run mode to the G65. On the back panel of the G65 it indicates to connect only one speaker to the master speaker row. In the manual it shows a multi DSP system where front left is master but shows a slave center connected to the master row. What's up with that?
I tried the connections both with only the left 3200 connected to the master row and also as is shown in the manual with the 3300 center also connected to the master row but it doesn't make any difference in terms of getting sound.
The back of the G65 is indicating which
row of RJ45 sockets the MASTER DSP must be connected to, SLAVE DSP's can be connected to either row.
Can you check the cabling and config are aligned with this.
You can use the G65's display to check that it is receiving a signal from the MS600.
Regards,
Carl
Google Search
|
Meridian Systems
|
Meridian Streaming
|
Restaurant
|
WiKi
|
Duncan's Meridian Info
|
Board Rules
|
Restaurant Rules
