Stefan,

Your comments actually are almost the same as mine regarding the quality, appart the ones I wrote above, and the fact that the front glass panel just came off after unpacking (double sided self sticking tape ....)

I managed to set the system up (without the room correction) and upgrade the firmware in less than an hour. I initially (and because I don't want to spend too much again on cables and because I use them allround), I used Supra interconnects. For the BW804 speakers I use ven-den-hull cables (at this time single wired, double wiring is in the process..) As a DVD, DVD-A, SACD source I use the excellent Denon DVD-A11.

For the calibration, I set the front, center and subs at 4 meters, and rear at 2,5 from the listening position all at level +0db (don't know if that is correct yet - I will do a better calibration, room correction etc later on). Room size is 10m by 5m low ceiling and rough walls (basement) [Linked Image from softronix.com]

One question to anyone reading this - how on earth can you set up on the G68 a universal DVD player (that plays DVD, DVD-A, SACD, CD etc)???? Initially I set it as 2 virtual devices (one DVD and one SACD) but I am sure there is a better way...



[This message has been edited by kacos (edited 07-06-2004).]

smile