Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems Wrong fuse for DSP3200 will cause it not to power up?

Jack

Try one of these or all (no order).

Did you double checked all your wiring?

1) Connect only the 3200 direct to the G68 and go with your PC in Mconfig and start calibration. So the 3200 should wake up and make noise.

If you get no sound try your other speaker so you know that your G68 outputs a signal.

2) Another way is to wire all your equipment/speakers as it have to be and turn your equipment out of standby. When your 3200 get power you should hear a small noise at the tweeter. You have to go very close to the tweeter to hear it.
If you hear nothing either the 3200 are not out of standby or maybe a internal fuse is inside the 3200.

3) Or simply power off the 3200 with the power switch and when you turn it back on you would hear the movement of the chassis-also go here very close to the speakers.