Hello,

I just set up my DSP5000C and have a problem with my left speaker.

This is set to Left Slave but the red master signal remains on. The speaker is not reacting to any comms. The comms are passing through this speaker to the right speaker that is working properly so I don't believe it's a cable issue. Just to be sure I have tried another comms cable.

I substituted a DSP3100 and this works fine.

There is no offered option to set the centre speaker as a slave.

I have now made the left speaker a controller, as well as the processor, and can use the system if I sync the volume separately.

Any suggestions?

Neil

1) MS200, G65, Revivers, DSP5000.2, DSP5000C.2, DSP3100, D1500, SME10/IV.

2) Mac Mini (Roon), Explorer 2, Sennheiser HD6XX.