Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems Need help setting up 562V and DSP6000

Thank you for the warm welcome, everyone. Everyone is so friendly and helpful here. You guys are heroes!

So my cables are Meridian speaker cables with two connections at each end (RCA & DIN). They are not identical. And it's D6000, not DSP6000. Every day I learn something new.

In the meantime I was able to connect them... Sort of.

I'm pretty sure I've got the hang of it now but I would like confirmation. Just to be sure.

On this picture you can see the back side of the 562V:

1. I put the black 240-DIN cable where it says COMMS. There are 2 COMMS. I used the left.

2. I put the black RCA SPDIF cable where it says Digital Outputs. Once again there are 2: Main and Tape. I used Main.



---

On the following picture you can see the rear of the D6000 Master:

3. I put the black 240-DIN cable (coming from the 562V) where it says INPUT GLOBAL.

4. I put the black RCA SPDIF cable in DIGITAL AUDIO D.


Then we go from Master to Slave:

5. I put the grey 240-DIN cable in the Master where it says OUTPUT LOCAL.

6. I put the grey RCA SPDIF cable in DIGITAL AUDIO D OUT.



---

On the third picture you can see the rear of the D6000 Slave:

7. Similar to 3.

8. Similar to 4.