Hi All,

I searched the forum but didn't see info on this, but if I missed this issue already being covered in another thread, please point me to it. So, I've had an issue for quite some time where the output zone on my Control:10 disappears from the zone list - even on the Control:10 UI itself. A simple reboot always fixes it and it does seem to happen only after long periods of system inactivity. Anyone else run into this?

My concern now is that I am about to get up and running on an automaiton system in the new house. The plan is for the Control:10 to be located at the rack, with it's output feeding the distributed audio of the house (I'll be using some MS200s as well, but also want to make use of the Control:10 zone) and my concern is that this issue creates a bit of a troubleshooting hassle. I guess I could investigate whether the system has a reboot command over IP control, but obviously at core the issue shouldn't be happening at all. Maybe it's a hardware issue on my unit (Control:10 early version)?

Jeff

Various