Your Pioneer flashes up over as you are overloading the analogue to digital convertor in the receiever - its the same on my LX83.

Your right a 6db attenuation in the MS600 browser config sorts it out but that is I believe independent and sounds different to me to the variable analogue volume control.

(There is a setting in the Pioneer to attenuate it called ATT, if same as LX83 slide down the panel on the bottom of the remote and its no.4 button I think).

I have just started a post on this so glad someone else has - when I feed my G55 power amp via the MS600 as a preamp it doenst sound 100% right to me, like it's doing the job but not really as good as a proper preamp / processor - this could just be where I am used to certain sound though

That's what I am hoping I will gain when I get a G61 - a real high quality sounding analogue preamp?

Last edited by EllisDJ; 2012-11-12 04:57.
861v4 LPSU, HD621, Bryston 9BSST
KEF Reference 3 and 2c, 2 X SVS SB13 ULTRA
Audio PC: JPLay, LPSU, JCAT, PPA Studio
Cables XLO Limited, Unlimited Edition and Signature
Sony VW500 Isotek Titan, DIY Mains and Clean Signal Earth Solution