Hi,

I recently bought a pair of DSP5k.1 24/96 speakers.

When running with a CD player directly into the DSP5k pair in standard master/slave configuration, both work well.

However, I have now attached these (using the appropriate type - 6, center y, balance n, n controller, 500, dd no) to my 568.2 I initially connected them using a similar pattern to that outlined in the 568.2 manual.

I.e. with regards to comms:

Master cable to 5000c center - comms out from center to patch box - 511 patch box to slave dsp5000 comms in - slave DSP comms out daisy chained to other in pair via comms in

I have also tried daisy chaining from center to L to R with center as master.

With this setup, only 2 of the speakers play - the center and only one of the DSP5ks connected directly (via patch box) to the center. Switching around speakers does not make a difference.
I believe I have typed/reset each speaker appropriately.

The only random setup that seems to work is center comms out to patch box and two separate comms to each DSP5000 (i.e. no daisy chain).

I am worried that there is something wrong with any of the speakers (although I feel that this is unlikely since only two speakers play whether they be center/pair or pairs together).

My DSP5000s have 5.030 firmware and the 5kc has the latest 5.21 firmware. Do you think that this could be an issue?

Any advice would be most helpful.

Thanks!

Last edited by B2nvs2001; 2012-09-12 16:21.
DSP33