Hello

Just acquired a G68ADV and trying to make the settings.

In the Room Correction section, I ran the program with a Sound level Meter connected to A8 (mic) and placing the SLM into the listening position.

the final result gave 0 filters and a flat line. I then noticed to have the following issue : Signal to Noise is poor (34Db) the minimum acceptable is 40Db for all.

I set the SLM weighting C and slow response then selected 90Db on the range.

Is there anything I am doing wrong ?

Second, trying to use the 12v trigger to switch on/off my power amp, and I do not know where I can find it in the menus (I found something on right click on G68 then properties then on source I select radio and changed trigger 1 to high, but it does not work, my power amp accepts 12V trigger)

Thank you

Last edited by Sapiens; 2012-02-13 08:36.
G65, 598DP, UHD722, DSP5200SE Front LR&C, Cable TV, Pioneer Kuro LX509