logo

Google Search  |  Meridian Systems  |  Meridian Streaming  |  Restaurant  |  WiKi  |  Duncan's Meridian Info  |  Board Rules  |  Restaurant Rules
Previous Thread
Next Thread
Print Thread
Rate Thread
Page 2 of 2 1 2
Joined: Nov 2006
Posts: 4,013
Likes: 1
Vogon Civil Servant
Vogon Civil Servant
Joined: Nov 2006
Posts: 4,013
Likes: 1
Originally Posted by gIzzE
Slight snag, I guess the speaker will not be sending a full range signal to that driver, it will be high passed I would guess?

Where is the crossover?

I presume the DSP/Pre amp section sets the crossover points and then that signal is sent onto the amp?

So probably no where to grab a full range signal from?

Why do you need to grab the full range signal? The sub is not going to go as high as the bass driver of the speaker anyway.


Sooloos, Roon, G series (with LPS upgrade), 800 series (with LPS upgrade), HD621, AC200, Prime and PS, DSPs old and new.

Purdeys, Moke, Leica, 'Blad. Only the best.
Joined: Jan 2004
Posts: 2,001
Likes: 10
Knows where his towel is
Knows where his towel is
Joined: Jan 2004
Posts: 2,001
Likes: 10
Originally Posted by dpstjp
Originally Posted by gIzzE
Slight snag, I guess the speaker will not be sending a full range signal to that driver, it will be high passed I would guess?

Where is the crossover?

I presume the DSP/Pre amp section sets the crossover points and then that signal is sent onto the amp?

So probably no where to grab a full range signal from?

Why do you need to grab the full range signal? The sub is not going to go as high as the bass driver of the speaker anyway.


It's the lower end I want.

I would expect the mid drive to be bandpassed from around 35hz to around 5khz, however, I want the sub to do 20-35hz, but I don't think that signal will be there.



No Darling, I've had it months!
Joined: Apr 2004
Posts: 12,733
Likes: 88
Don't Panic!
Don't Panic!
Joined: Apr 2004
Posts: 12,733
Likes: 88
Mid bass driver does everything below the tweeter x-over (i.e. all the way to 35Hz, I *think*). There may be other filtering.

Bass driver is (analogue?) low-pass filtered and only deals with the bottom end, I *think*.


Roon Developer and ex-moderator of this Forum
I am #25 in the HH1 photo of fame.
Joined: Jan 2004
Posts: 2,001
Likes: 10
Knows where his towel is
Knows where his towel is
Joined: Jan 2004
Posts: 2,001
Likes: 10
Being an electronic crossover it must be bandpassed as it can't send 20hz to that small 6" driver.

It is shame we can't hack the firmware to give the bass driver 'everything' below the crossover, and then simply send that signal to a sub instead and completely disconnect the bass driver.

I have to admit I thought the two mid drivers were doing the same thing, but never really thought about it before.



No Darling, I've had it months!
Joined: Sep 2007
Posts: 1,986
Likes: 55
Knows where his towel is
Knows where his towel is
Joined: Sep 2007
Posts: 1,986
Likes: 55
Originally Posted by gIzzE
Being an electronic crossover it must be bandpassed as it can't send 20hz to that small 6" driver.
It doesn't have to, but it may be band limited to 15Hz; no music down there and 15Hz is normal for warp filters (remember them...)


Originally Posted by gIzzE
I have to admit I thought the two mid drivers were doing the same thing, but never really thought about it before.
This type of speaker is normally known as a 2.5 way, the 2nd low driver has an additional low pass filter to extend the low end whilst not smearing the midrange.

I think you should give it a go for the price of a few metres of cable.

Steve.

Joined: Jan 2004
Posts: 2,001
Likes: 10
Knows where his towel is
Knows where his towel is
Joined: Jan 2004
Posts: 2,001
Likes: 10
Originally Posted by Steve Eyles
I think you should give it a go for the price of a few metres of cable.

Steve.

Agreed, I will have a bash tomorrow.


No Darling, I've had it months!
Joined: May 2006
Posts: 79
Likes: 1
Mostly harmless
Mostly harmless
Offline
Joined: May 2006
Posts: 79
Likes: 1
As usual,

Outstanding advice.

I think I will pick up a 568.

I have a B&W 800D 7 speaker set up / DD-18 sub / MBL DAC / Sony CDP-1 / Bluray /
HD PLAYER / all high interconnects & plugs / Bryston Amps / Sony VPL200 projector--as my main system

I have the older Meridian gear in same room so I can mute main system and watch recorded sports & game shows while listening to some good 2 channel music.

Probably a better way to do this, but, my technical expertise is limited at best.

Dave


DSP7200SE / DSP5200 / 861 v4 / 218 / C15 / Oppo 205 / DSP5500 Center Piano Finish
Page 2 of 2 1 2

Moderated by  Carl, Duncs, ncpl 

Link Copied to Clipboard
Who's Online Now
3 members (MI', bxd, JDavies), 298 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newest Members
Kiran1103, Tony999, PhilP, Grover, Humberto
5,503 Registered Users
Top Posters(30 Days)
Ludwig 10
AngryGM 10
IanP 8
Top Posters
VirusKiller 12,733
ncpl 8,816
Carl 8,506
Fiddler 8,364
Ian 7,950
Forum Statistics
Forums18
Topics31,247
Posts297,428
Members5,503
Most Online4,788
May 22nd, 2026
Meridian  |  Media Centre  |  Support  |  Firmware Release Notes  |  RSS Systems  |  RSS Streaming  |  RSS Restaurant

Website Provided by Mr Tech Guy - Resolute Audio Visual Limited © 2026

Powered by UBB.threads™ PHP Forum Software 8.0.1
(Release build 20251126)
Responsive Width:

PHP: 8.5.12 Page Time: 0.033s Queries: 30 (0.025s) Memory: 0.6607 MB (Peak: 0.7302 MB) Data Comp: Off Server Time: 2026-11-13 21:57:41 UTC
Valid HTML 5 and Valid CSS