Thanks for the measurements Cliff.
No, problem
Yes, the same or very similar
In that picture, the 245mm is presumably the horizontal distance from the right side of the fan housing to the right hand side of the unit, on the right? In other words, the space that is half ocupied by the SMPS? So if the fan could be relocated to the left, there would be about 300mm available?
Yep
And when you say "the central board retaining struts", do you mean the plastic brackets that aren't visible in the above picture, but can be seen in
Meridian G61 Internal view of the G61?
Similar, but in the G68 they are not so extended, i.e. while they taper so that they are wider at the bottom but the angle is much steeper.
So that there's 120mm available without having to cut the struts in the G68? That being the case, there would be nearly enough space for the 60W Acopian 51212T9A at 235x87x130 (which I've just bought). I have high hopes for a G68 with a linear supply...
Thanks, Nick
Yes, the 120mm is from the bottom of the struts. With the 51212T9A there would be some scope for raising it slightly and/or cutting into the struts. It would be a tight fit and avoiding the connectors on the front boards may be the biggest problem. Adequate cooling may also be a problem.
Cliff
Google Search
|
Meridian Systems
|
Meridian Streaming
|
Restaurant
|
WiKi
|
Duncan's Meridian Info
|
Board Rules
|
Restaurant Rules
