Mr Meridian emailed you the files.
I sent you PM and I have just sent you a another one.

IMHO I don't think you need any more copies.


So just to be clear on this:

You MUST load the firmware into the 568 i.e.. no "BAD SOFTWARE" error message at power up after completion.

If you get "BAD EEPROM" after power up, that is OK; it just means the 568 needs to be re-typed (ie restored to a factory default).

You can do this; it does not really matter what type it set as it will be over ridden by the Legacy Configuration Program.

If you can't get passed the "BAD SOFTWARE" message.

STOP: Do NOT attempt to re-type it will not work or help.

It may help loading the firmware to slow the baud rate down on the RS232 communications. You will need to go to the COMM port properties on your PC and select a slower speed 9600 Baud would be a good start.

If you get stuck, please describe what you did, how you did it and what the PC and 568 displayed.

Without taking this approach you (we) will be going round in circles.

Regards,
Carl

861v6+ID40, HD621, 8000.2, 7200HC, 7200.2, SKYQ Silver, PS3, PDP-LX6090, QNAP TS870-Pro (8*6TB), Roon, iPadAir2.
[In Reserve] C15, MD600 (2*3TB), TwinStore RM (2*2TB)