I think I screwed the pooch when I "fetched". When I opened the Legacy config program I really wasn't sure what to do. There are a few ICONs for fetch, add products, etc. and I got a little twisted. First it asks about your remote so maybe the real configuration is done thru the remote.

I could also choose to "add product" and it lists 568. Well am I supposed to? Or was this for a plain 568 and not my 568.2mm? I could also "add" DSP33. Should I?

I assume I can reload the firmware from scratch but am unclear what to do when I open the legacy config program. There isn't much there to choose from.

I had a sheet I downloaded from Meridian about updating to 2.5b9. It confused me as it did not describe the same screen image I saw on the Legacy config screen. It said to "fetch" so thats where I think I messed up.

I saw no screen or icons to really configure my system in that very limited Legacy application.

G61R, HD621, 3xDSP33 (front, center left), 2xD1500 subs, 2xDSP420 (rears), Sonos everywhere.