I would still make a go of it telling your system all speakers are large and no sub and disconnect the sub to be sure. then play some music at a moderate volume and see if there is more bass there/ a more pleasing result. you could have a sub placement issue, speaker placement issue that Trifield is highlighting for some reason.

another way to try the setup is to use the speaker level setup with the processor configured to no sub, large with protection and then use the subs xover control to cut the bass where it naturally rolls off the mains. with all speakers set to small it means all the xovered bass is going to the sub and the sub location could be an issue. also, using the protection circuit is not like a crossover- based upon the values you put in it acts as a dynamic range limiter- so it will try to make sure you dont blow out a speaker from too much SPL. Ive found that its presence is very hard to notice.

[This message has been edited by JerryL (edited 08-10-2003).]

[This message has been edited by JerryL (edited 08-10-2003).]


Best regards,
Jerry
Main System: 861v6, DSP8000s in corners, DSP7000s Center and Sides, 1-9 humans.