Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems Individual speaker configuration -- is it possible?

I have 3 different types of DSP speakers -- 6000's, 5000's, and 33's. They are in very different locations in the room. Therefore I find that I wish to configure different settings for bass and tilt.

So far, though, it appears that I can only have one configuration for bass and tilt. When you press Function-Store on the remote the configuration is enabled. I would prefer to have the Function-Store key bring up an individualized configuration stored in each speaker. Actually, even better would be to not have to press the Function-Store button at all -- the configurations should come up automatically as the default.

The above is not quite correct...I find that my configuration applies to the 6000's and the 5000's but not the 33's. Does anybody know why?

I can tell you that just getting to this point was difficult. Meridian has conflicting and incomplete instructions distributed among various manuals and white papers.

you're being kind about the documentation.

it's a mess :-)

doody.

If I remember correct you can disconnect the comms and then configure each speaker individually and then reconnect.
I think Mr Spears will give you the correct answer!

[This message has been edited by Mikael (edited 02-19-2002).]