Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems Can't access DSP tone controls - where have they gone?!

Strange... I no longer have access to tone controls in the DSPs. I hardly use them but they used to be there and I can't access them now.

System is 210 > AC200 > 5200SE

There's a tone control on the AC200 but I can only access that via the front panel. Nothing via remote, which is an MSR2.

Both DSPs are set to controller 'auto'.

The cursor buttons are showing a red light on the MSR2 when pressed, and the Fn-shifted cursor buttons show the green light, so the remote does seem to be sending different commands.

Any ideas?

Cheers,

S

Bump... any ideas?

Are the controls available on the AC200 ?

Thanks, Nick.

Yes they are (and they work), but only accessed on the front panel.

S

Maybe the AC200 is controller and the type setting of the DSP means no tone controls. Set a DSP to master and controller and see if the option returns.
I never use the controls here so am just going from memory.

Ah that's a good idea - thanks, Nick. I will give it a go...

Yup that worked! Many thanks, Nick.

It did need to have one of the DSPs as Master and Controller at the same time. It might have needed to be the one on the AC200’s Master output too. It took a few goes for everything to work properly and power up.

Cheers!