Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems Adjusting Room 2 Output Level On 561

Hello Everyone,

I have a 561. I believe it does not have the Tape module installed, because there is no headphone jack.

I have the Room 2 outputs going to a Stereo Receiver in another room. I know how you use the copy feature to select the sources, and how to use the copy mute feature. But I can't fine anywhere in the manual that says how to adjust the output of the Room 2 signal. I realize it is a line level output, but is there any way to adjust its output? I now need to set the Volume on my second room receiver higher than I had to when I had a different preamp (A Kenwood KC-105) sending the signal to it.

I know the 561 lets you adjust the sensitivity of the Analog inputs. Is there any such feature for the Room 2 outputs?

Thanks in advance!

Dan

Hi Dan,

I think you need the 561M module in order to adjust the Room 2 outputs...

Try Function volume up/down, but I suspect it only works if the headphone module has been installed.

Cheers,

Steve

Thanks Steve - I tried, but no luck.

It's not the end of the world, I just thought there might be a setting I was missing.

Dan