Is there something I should look for that is obvious? Such as a fuse or something?
Thank you
Oppo UDP-203, Sonos, Nvidia Streamer, Fire TV 4K, Trinnov Altitude32 into Dan D'Agostino Momentum into Wilson Alexx, Paradigm Sub 1, Monitor Audio In Wall surrounds, JVC NX9
Yes there is a fuse in the housing where the power cord plugs in. It is very unusual for one to blow. If it is blown, replace it with the same type.
There is usually a spare in the fuse holder. If it blows again, there is a serious problem inside the speaker electronics.
I assume you have no display lights at all?
www.cmbintegrations.com One step from the Presidency #1 Trinnov Altitude 32-8-16, 271, 8000XE, 7200SEHC, 7200.2, Seaton F18, JL Fathom F113, Revel w990's, Kef R7, ATI 528 Amp, JVC RS4100K, SI screen. Roon Nucleus+, Eno AG, Eno M link, 218. #2 Mark Levinson No5105, Ayre VX8 and CX8, Vandersteen Treo CT, Preamp varies. #3 Meridian Ellipse
Thanks all. Yes there is absolutely no display and the slight hum when it powers on is absent. So clearly something early on in the chain.
Any idea of the fuse rating? Would like to have a spare handle when I open it up.
Oppo UDP-203, Sonos, Nvidia Streamer, Fire TV 4K, Trinnov Altitude32 into Dan D'Agostino Momentum into Wilson Alexx, Paradigm Sub 1, Monitor Audio In Wall surrounds, JVC NX9
Oppo UDP-203, Sonos, Nvidia Streamer, Fire TV 4K, Trinnov Altitude32 into Dan D'Agostino Momentum into Wilson Alexx, Paradigm Sub 1, Monitor Audio In Wall surrounds, JVC NX9
It was the fuse!. There was a spare fuse inside which was very helpful as I didn't have to worry about the quality of the replacement.
Thanks all.
Oppo UDP-203, Sonos, Nvidia Streamer, Fire TV 4K, Trinnov Altitude32 into Dan D'Agostino Momentum into Wilson Alexx, Paradigm Sub 1, Monitor Audio In Wall surrounds, JVC NX9
That has been my experience. Maybe here in the US it is different. As a dealer I have never had to replace a fuse in a speaker that didn't have a problem on the electronics board and that was only once. As an owner for twenty years the same is true.
www.cmbintegrations.com One step from the Presidency #1 Trinnov Altitude 32-8-16, 271, 8000XE, 7200SEHC, 7200.2, Seaton F18, JL Fathom F113, Revel w990's, Kef R7, ATI 528 Amp, JVC RS4100K, SI screen. Roon Nucleus+, Eno AG, Eno M link, 218. #2 Mark Levinson No5105, Ayre VX8 and CX8, Vandersteen Treo CT, Preamp varies. #3 Meridian Ellipse
Mine regularly blow when I have a power spike after an outage, so a couple of times a year. I have a pack of fuses in a drawer thanks to my dealer.
You should take care of power outages, as they have uncontrolled voltages and can destroy a lot. Your power distributor have to protect you, that is usual here in europe. You should search for surgery circuits, and install them. That is my strongly recommendation.