well, Im standing here in my equipment room for quite a while now trying to get MRC to work and having a miserable go of it. For some reason the SN ratio is too low on many channels. Did I move the speakers into nulls?

Go back a few hours... I took some time off today and I set up all the speakers as free- Hooray! We're free!!! smile Listened to a few minutes of the new Foo Fighters album, as I had listened to it recently in the theater. First impressions are that the sound is not only more cohesive but the bass is more involving and deeper. I can hear that the bass is tripping over itself a little bit at the lower end, if that makes any sense- its just too much- but its not nearly what it used to be and I think moving the speakers out into the room more has been a big help.

Wait a minute- as I am moaning about this I see I am getting SN responses all above 40db! I should have started whining earlier! I was using 80 weight with fast and I decided to give 90 a try- its working!!!! (using 0.5v sensitivity)

So the Foos sounded better and I tried my old MRC profile from the old readings just as a comparison and the result was way too thin sounding.

I then fired up the new Rush album for some good instrumental rock and this was really terrific- the movement of the speakers now makes the soundfield seem more unified which I really appreciate but the bass again was a little too plentiful towards the bottom.

WHOA- the RC worked!!! now its calculating- that will take some time as I am using a 8 or 9 year old Sony laptop which sole purpose is to run MConfig.

Gonna try it out and report more later...

best regards,
Jerry

Best regards,
Jerry
Main System: 861v6, DSP8000s in corners, DSP7000s Center and Sides, 1-9 humans.