OK. After my Cedia "faux pas", I'm going to be as unambiguous as possible.
The following are all G68/861 processing questions:
1) Is the stereo PCM bit-depth auto-sensed?
2) Assuming analogue or 24-bit capable speakers, are all stereo PCM inputs automatically resolution enhanced to 24-bits? (518 functionality)
3) Could we be given the ability to set a custom amount of gain for each digital input (518 functionality). For instance, I listen to radio from Sky with +4dB of digital gain using my 518 and it never clips.
I'd also like to take a different tack on the HDMI issue. I accept that some or all of the following questions may be considered unanswerable for technical or commercial reasons:
1) What does Meridian feel are the key challenges of audio over HDMI?
2) If one feeds one's HDMI sources directly into a video processor (to enable input-specific calibration) and said video processor delays the audio to compensate for video processing latency, what implications might this have for audio over HDMI and clock recovery? My point is: Does Meridian need to get at the HDMI stream before anyone else messes with it? This clearly has implications for third-party compatibility.
3) Does Meridian consider an HDMI solution able to handle LPCM over HDMI adequate (distributed processing solution) or would the ability to decode bitstreams of the new "HD" formats also be required.
4) Does the architecture of the G6x/861 allow for eight-channel digital inputs? i.e. Are the current multi-channel inputs tied in firmware or hardware? Presumably increased processing power could be added to the 861 if required, but even if eight-channel inputs could be accepted by the G6x is there enough processing power in the G6x to handle eight channels?
5) Six-channel MHR was approved by the DVD forum, but the HDMI standard is maintained by a different body. Does Meridian foresee any problems with an potential extension of MHR to eight channels and application to audio transmitted over HDMI? For instance, a Meridian box that accepted HDMI and output HDMI (for video) and eight-channel MHR would seem an elegant solution.
Finally, I would also like clarification on the following question:
1) Is there an all-Meridian/Faroudja video solution which will allow the display of 24fps NTSC film material at a internal display rate that is a multiple of 24Hz. i.e. a 480i60 --> 1080p24 or 1080p48 judder reduction solution. If not, what is the possibility of enabling 480i over HDMI from Meridian DVD players?
Thanks in advance JK. Enjoy CES!
Joel