It is time to add my two cents to this discussion as my name and reputation has been raised in at least one of the posts.
First off, I sold the DSP6000C to Dave. It was in immaculate condition and worked perfectly. Many of you should recognize my user name: worldattorney. I have sold tons of "kit" both new and almost new on Agon, eBay, and recently on Hitch with only very satisfied buyers.
I repeat, the 6000C worked perfectly at ALL volume levels and did not have any over heating problem and this speaker was driven at 85 an 90plus relative volume levels (after room calibration and proper set-up)
Since all of my 6000's, 5500's and 5000's were gone, I gave dave my spare parts inventory with the speaker.
He informed me that when he hooked up th 6Kc that he heard crackling, he then disconnected that driver and removed another driver or something like that - the point being - Dave was performing diagnostics and repairs that were above his ability. I just have this mental image of my speaker in 5 pieces, while one or two woofers and being driven at "95" while two others are hanging off bar wires.
This entire story is very suspect. Not that Dave is not telling the truth, but that Meridian dealers and Meridian techs are telling him that you have to turn down this speaker to 75 or it will heat up and blow out? BUT, if you buy a pair of $30K 7000's all your problems with be over, but first spend the money to upgraded these very very early serialed numbered 6000's for $5,000.00+. Oh, don't worry, we'll all fly out to your house to sort everything out.
This is a bizarre story.
Bottom line I am trying to get across, Dave is having an experience that none of us - fortunate that we are- have ever been through.
Just as a test, I ran my parents brand new 5200's at 99 for thirty minutes today while we were out of the house. They played perfeclty - no distortion - no clipping - no over heating.
MY 8000's I suspect will be no different.
Dave should dump all of this gear and start fresh