Hi Nick,

Looks like that monitor would give you some good info. I only used voltage monitoring and here in the states we use 120VAC. So the current demands are higher. Keep in mind it monitors RMS current/voltage not peak. Although with a 15amp circuit here in the states I see dips of up to three volts RMS with a 200 watt per channel amp. The wiring was only 6 feet from the electrical box. The transformer in the power conditioner bothers me. I would use one conditioner for each speaker. I'm not sure about the D6000 design either. Is there a separate power supply for each amp or is it one transformer? The more transformers you parallel together the lower the impedance and then we don't know about the power conditioner impedance that is most likely higher than the transformer on the pole outside. Its all speculation. I just think Dave should try directly into the wall to prove it out.

Ron


HT: 568.2mm (Revelation One filter), 518x2, SB3, Bryston 7BSTx3, 8BST, Aerial 10T, CC3, SW12(Qty2) w/SVS AS-EQ1, MK Tripole x4. JVC RS1u, DVDO Duo, Oppo 103 w/Vanity103HD, Sony PS3, VIP 3D Theatre, Acer H5360. Logitech Ultimate Remote and Hub.