|
Working on the ultimate question
Joined: Feb 2004
Posts: 1,560 Likes: 1 |
Djones1915,
All three front speakers are connected through one conditioner and one extension cord? I wouldn't do that. Amplifiers are best to be connected directly to the wall. I do however use PS Audio Ultimate Outlets but these are only baluns with double 8awg wire that have 8 turns around the balun so it doesn't limit current. Be careful with power conditioners and amplifiers. If the bass looses any tightness or punch with the conditioner then it is probably limiting current. I can hear it at moderate volumes. The sound usually looses that toe tapping quality. If I were you, try connecting directly to the wall, each speaker with its own extension cord. Also, how far is your audio setup/room from the electrical box in your home? With three 100watt amps and six 75watt amps (three front D6000), that too can be a problem on any long run 14awg wire. Amplifiers draw a large amount of current during large musical peaks. Even amplifiers with 100,000 microfarad storage capacitors will draw a lot of current during peaks. I have four 20amp breakers with 10awg wiring in my setup and put two amps on each circuit. All my digital front end is on its own circuit as well. I'm also only 10 feet from the electrical box. Very stiff power rail with this setup. Very little sag under dynamic conditions.
Ron
HT: 568.2mm (Revelation One filter), 518x2, SB3, Bryston 7BSTx3, 8BST, Aerial 10T, CC3, SW12(Qty2) w/SVS AS-EQ1, MK Tripole x4. JVC RS1u, DVDO Duo, Oppo 103 w/Vanity103HD, Sony PS3, VIP 3D Theatre, Acer H5360. Logitech Ultimate Remote and Hub.
|