|
Working on the ultimate question
Joined: Feb 2004
Posts: 1,560 Likes: 1 |
Hi George,
The amplifiers are in the 75 watt range for each driver I believe. Most of that power isn't needed for the high frequency drives and may be over kill and waisted. Remember the max voltage range of the amplifier is a lot lower than a 400 watt amp. So if the impedance rises to high then peaks might hit the voltage rail. I would think M designed it to have plenty of headroom in the top end though. It would be pretty loud by then. The highest power levels is needed for the low bass range. How big is the bass driver amplifier? I'm not completely familiar with the DSP speakers but I'm sure they are not designed for sustained SPL over 110dB. We are talking 15 to 30 minutes of sustained high level sound. The 114dB rating is dynamic peaks not sustained SPL levels. It would be good to find out what his calibration settings are so we can get a good picture of what might be wrong. Like you said if the cal setting are 0 - +5 then anything over 83 - 85 is probably clipping the amplifiers on peaks. Thus his over heating and distortion. IMO
Ron
HT: 568.2mm (Revelation One filter), 518x2, SB3, Bryston 7BSTx3, 8BST, Aerial 10T, CC3, SW12(Qty2) w/SVS AS-EQ1, MK Tripole x4. JVC RS1u, DVDO Duo, Oppo 103 w/Vanity103HD, Sony PS3, VIP 3D Theatre, Acer H5360. Logitech Ultimate Remote and Hub.
|