Hi Snowflake

You'd be best to have the 568 as controller. If anything else is allowed to control, you will run into problems.

I think the broader issue here is that you need to have each of the 596, 568 and 562 set up to recognise every input source. It sounds as though you don't have the rig set up that way at present, which is why the 568 is only reponding to one input selection (TV in this case). I'm assuming that you have all analogue sources going through the 562 and and all digital sources going directly into the 568? Before I launch off on a comprehensive input mapping list, can you confirm what sources you have, and what they are connected to?

Cheers

George