No large interest in this subject, but if I insist then maybe someone will comment...
This is more how the Home Theater is placed right now. I have marked possible places for the two subs with red letters, A to G. At position G, the sub has to be further left than the letter indicates, saw that a bit too late...
![[Linked Image from img79.imageshack.us]](http://img79.imageshack.us/img79/5713/vardagsrum5oe.gif)
Since I have one sub that is connected analogue (the Velodyne DD-12), and the D1500 that is connected digitally, I can't have the subs as a stereo pair. They should instead be a mono front sub and a mono rear sub.
Which sub should be the front sub? The DD-12 is the better sub that goes lower and outputs a higher SPL. So it ought to play "the most" bass. Usually a movie or multi-channel music mix has more bass at the front. Seems like the DD-12 should be the front centre sub. But my Bc Acoustique are large front speakers with good bass capacity, better than my DSP33 rears. So maybe the DD-12 is more needed at the back? I would guess at the front anyway, but that's just a guess.
Some possible combinations of sub spots are: "A + E", "B + G", "B + E" and "A + G" (I don't differentiate between D and E here). What do you think would be a good combination? All doors to the room are closed when the system is used, three of them are glass and one wood.
I also think a little about Bass Management, here's a picture from MConfig, it's easier when having a picture nearby. The settings are random, nothing I currently use:
![[Linked Image from img114.imageshack.us]](http://img114.imageshack.us/img114/221/bassmanagement1va.gif)
The Crossover setting, does it only affect the sub, the frequency under which Bass Management should send bass meant for other speakers (when set to small) to the sub? Or is also the bass meant for the other speakers, lower than the crossover, removed from them? Or is the "Size" setting for the speaker when calibrating deciding this? So you can have an overlap of frequencies? Any correspondence between speaker "Size" and highpass frequency for that speaker? When to let frequencies overlap, and when not (to lessen available combinations)?
Velodyne says to use the crossover in the sub instead of the reciever, but possibly a G68 does a better job than the DD-12 with the crossover?
Should the best placement for the two subs be done totally independently, or should I first try to find the best spot for the D1500 (using the sweep generated by the DD-12, the mic and the frequency response display) and then let it play while searching for the best spot for the DD-12? And calibrating the DD-12?