Well, having checked in MConfig the Front Centre can only get bass redirected from the three front speakers, the Rear Centre can only get bass redirected from the surrounds. But I guess both will also play the full LFE track?
My fronts are normally set as Large, they go comfortably down to 35Hz (but drops off pretty steep after that). Then I have the DSP5000 center and the DSP33 surrounds. What if I would set all speakers as Small, but the crossover as low as 50Hz (and then measure and try what seems most suitable)? Am I correct in thinking the crossover only affects Bass Management, not the LFE track (for LFE there's the "LFE low pass filter")? What could be a good frequency to start with for that filter? 80Hz? Is there any problem with having the Crossover and LFE lowpass at frequencies wide apart? Will eventual LFE material above the lowpass filter freq be "lost" - or distributed to other speakers in the system? But only if they are set as Large?
Or should the LFE lowpass filter be set to "Flat" for the DD-12? But not for the D1500?
HD621, G98DH, G68ADV, Bc Acoustiqe ACT A3, 5200C DSP33, NuForce Reference 9 monoblocks, 2x SB3's, Velodyne DD-15 & DD-12 Subwoofers and a Meridian sub.
|